I’m looking for suggestions on a good 9mm hollow point round. I have a CZ P07 and I don’t want to spend a bunch of money trying several kinds. Trying to shorten my list for a hollow point that will feed reliably.

Thanks for the help!

Well... that's a wide open question. Most modern handguns feed most modern ammo. Beyond that it depends on your application and tolerance for the cost of ammo. I don't think you can go far wrong with the hollow point offerings from Speer, Hornady and Federal.

Hornady Critical Duty or Critical Defense, depending on barrel length.

I carry the 124 XTP, usually in the American Gunner or Custom load.

I get the 50 packs of 124/147 grain HSTs. I get same thing in 165 grain 40 S&W and 230 grain 45 ACP the 50 packs are where the value is at.

All my carry guns get Buffalo Bore ammo.

HST

Speer Gold Dot.

Critical Defense

A 9mm might expand, but a 45 will not contract.

X2

The only defense 9X19 I have I didn't build myself is Hornady Critical Defense but I would buy Speer Gold Dot the next time if it ever happens.

The Critical Defense/Critical Duty is a far better bullet with that polymer tip. It penetrates car doors, glass, sheet rock, layers of denim without clogging up and still expands perfectly within the body.

We switched about 10 years ago, far after Atlanta PD made the switch, and their numbers proved this was a better bullet design.

Gets my vote as well.

I carry Hornady 125xtp in the american gunner line. I shoot the ammo that I have been carrying about once or twice a year and reload with fresh ammo. Once I have used it all up, I may take Wade's advice and go with the Critical defense. But, I bought a bunch of it, so that will be a while. For most non LEO carry folks, any modern HP would probably work just fine.

The Hornady Critical Duty had too many feeding issues for us to use. If your gun likes them, they do use a good projectile design.

If not my recipes, Hornady American Gunner in .380,9,40 and 45.

Doubletap 77 grain all copper hollow point. Look at the ballistics!

Same. They both feed well in my EDC CZ-75 clones.

X3

I had feeding issues with certain Sig/MecGar magazines. The magazines would be gritty or textured on one side and gloss smooth on the other, not sure which was correct, but if the gloss smooth was on the inside they would feed fine, if the gritty texture was inside the magazine, they would tumble. Of course they were 357sig and none of the 9mm people had issues, but to be fair we always had issues with 357sig from
Speer & Winchester. They run flawlesssly in the Glocks, being 9mm+P+ they have just as much oomph as the 357sig.

Underwood 200gr in XD 10mm
Underwood +P+ 115gr in 9mm Hell Cat
Underwood +P+ 115gr or +P+ 147gr in XDM 9mm

9mm
Underwood +P+ 115GR. TAC-XP
Buffalo Bore 9MM +P 147gr. Hard Cast FN

357sig
Hornady 135 Critical duty
Underwood 115 gr pen but just bought some double tap 180gr hardcast

Thank y'all for the recommendations!

+1

My Omni doesn’t like the 124 +P so I carry the 115 standard.

Bought a 1000rd case of 147gr. Winchester Black Talon years ago, sold some shot a bunch still have a few left for SHTF.