Anyone tried their barrels / chassis ?

I’ve got the full set up, chassis, forend, buttock, grip, and barrel. It’s a solid setup. Barrel is nitride coated inside and out, and they have a lifetime replacement guarantee. I have 2 complaints which are very minor, the cheek piece is a tad too small, and some of the edges are pretty sharp. They are aware and making adjustments. The stock is very light. They do have a heavy weight you can add to the stock to help with balance, but I think I’m going to change it out for a Magpul PRS. Buttstock and grip is compatible with any AR accessory.

They make their own barrels from stainless stock. As far as accuracy goes, my 18 inch 308 put 3 Federal GMM touching at 100 yards. Can’t really complain. They are 5R with button rifiling.

https://www.getoutlier.com/

And they are made right here in Greenville, Texas

@bigPig- I really appreciate you sharing this. Did you order all the pieces from them and assemble yourself ?

They have a code “LOWEST” and it’s 25% off their entire website I think. Wade put me on to them and I’ve been thinking about getting a chassis from them.

No. It can easily be done as their barrels come with a barrel nut. Truth be told, most of the guys there are friends and clients of mine.

Did you use a R700 action ?

I’m gonna gather a bit more feedback and then I’m seriously considering it.

Yes, a short action.

If you order a barrel, get the deep flutes if you go no taper, or get the MTU contour.