This is my first time adapting a carbon fiber stock to my needs. I just opened up the right ejection port for a left bolt right eject action. I’m also going to do some work on the barrel channel.

Do I need to seal this with anything specific?

paint


should have waited for me to sell my Manners EHA1

JK. looking forward to your new rifle

This manners is already inletted for the TL3 LH. All I have to do is make it right eject and open the barrel channel

Paint on that stock...probably a flat black after taping everything off.

Use the same colored gel from McMillan if it's that type of stock...

Well my wife told me it looked like dog [censored] so I had to break out the files. Wish me luck, or at least for her to go back in the house!

Well she was right, I am now smoother than the factory finish.

I clearly need to bed the lug, how about behind the tang? Anything else?

I think my work today is done.



All the tools needed. Probably in excess. All you really need is a socket and sand paper but I had to build it with math instead of a built action.

youre quite the stock maker

It's a chassis...shoot it first and see how it shoots before you bed it. I bet you don't have to bed it.

If you had plans to bed it you could've saved some weight ordering without a chassis.

Looks good.

Still looks like a dog's [censored].

You don't have a straight ruler laying around?

Nothing a little synthetic welding rod can’t address.