I picked up a pair of these to try out and I can say I’m very impressed. I own more expensive rings but nothing with the fit of these. They are built and anodized with an undersized bore, then clamped to a fixture in pairs and line honed. They also have alignment pins to align the top and bottom half which is a very tight fit. They’re then serialized as a set as well as which top to which bottom. I haven’t mounted them yet but hopefully they’re as impressive in use as they are in first appearance.

Well, they aren't cheap, so I hope you would be impressed...

example... https://www.shortactionprecision.com/products/area-419-match-scope-rings

They are nice but look like they would pair nicely with a 30+ ounce scope

Yeah, may be a bit much for a rimfire but something has to go on it. Stupid Europtic still has those XTRII 3-15s on for $499. 30.4 oz so you nailed it. I’m deep into this just because i could get the scope cheap.

Do these rings make my scope look fat?….

That is purty. You going to start shooting 22lr comps?

Not likely, just a little project.

They're just outstanding. Built like a mack truck! I have them on my custom 6.5 Creedmoor.

They look bobo proof ! they look almost as good as ACE

I have the one piece version and they are nicely made and I paired mine with a 45+ oz scope.