My rifle has a trigger pull that is frustratingly heavy. Is there an easy adjustment for this? If not, any recommendations on gunsmiths in the far north Dallas area to do this?

Thanks!

If it is an A-Bolt II, there's a simple screw adjustment.

I think you have to either pull off the trigger guard or the whole stock. There should be a small screw next to the trigger. It will tell you in your owners manual.

also can change out the spring or cut a few bands from the factory spring - only do with experience or see a gunsmith.

dont cut the springs. if its an abolt I, timney makes replacement trigger springs. midway has them on sale i think...

I just took mine down for after-season cleaning. You just remove the two screws that hold the trigger guard on and the screw is visible at the bottom of the trigger assembly.