I'm going to buy an air compressor and impact tomorrow

I've been following this since the beginning, you've done a hell of a job and that burb is bad arse. pics have been awesome

Id say you are much more than just a internet/youtube mechanic. You have a knack for it for sure. Awesome build, awesome fish.

Whew... I'm SPENT

started at 8, pulled all control arms, swayback links, etc

Just finished after burning out the old bushings and using a vice to pop new ones in.

Continued the all MOOG front end components

Tomorrow's customers had to cancel due to work so tomorrow I'll do the rear swaybar bushing, transfer case fluid, transmission fluid, filter and gasket, front & rear differentials and take a freaking nap, lol

Sounds like you got a busy schedule, but you've done more than most people would. And those fish are ridiculous! Nice!

I'm a workaholic and alittle OCD, ADD and a perfectionist

I appreciate you all following the build and for all the kind things you have said.!

I know how to catch a few lil fish every so often

Rearend differential fluid/gasket change done

Alignment done

Tightened recover hitch wobble with two washers tacked on

Tighten two hook shackles by adding 4 3/4" stainless washers underneath

Got the transmission pan dropped, cleaned, remounted and filled w fluid.

Also managed to give the black components under the god a cleaning

Topped off the stearing fluid to

Will get the transfer case filled tomorrow as I had to go grab a flexible funnel

Transfer case drain plug was thrashed, drilled it out, used a tornado bit to get ood one out & replaced it then filled it up

Added a rod rack to the roof in rear compartment

Programmed new keyless entry remote.

That thing is way to pretty to be hauling around any gut shot does.

I'm getting a reciever hitch basket for the front for hunting season

LMC parts showed up



Got all three rear hatch seals replaced the lift glass was an sob

Also got the new wiper spray nozzles installed and new grille support bracket installed

The front driver side ABS sensor went out during the control arm bushing swap, may have hit it with the dead blow hammer.

Light on the dash came on and had intermittent abs failure

Swapped it with a new sensor last night and is working fine today and no light in the dash

Sway bar is bent causing done slight popping

Ordered a new Hellwig swaybar

Trying to locate a set if tunable end links for a 4-6" lift but it's being a chore

New Hellwig sway bar came in today

Got the old one out and the new one installed

Marathon seat covers in Mossy Oak Brush came in tonight, couldn't wait to get em on!

Dang nice!!

Thank ya

Almost 20,000 views!

Posted for sale in the classified section

Time to buy a house and need to free up some cash

For sale in the classifieds

Bump

Bump

Bump