By tomorrow afternoon we will have a green Line-X'ed suburban!

It's nearly all taped and ready to shoot.

That is too nice to be driving in the pasture.

Na, it's bulletproof now!

Nicely done on all the repairs and upgrades--this made for a dang interesting/entertaining topic.
I'm thinking about new seat covers for mine; do you think that Marathon's are the best value or best available?

Very cool. Glad I found this topic. Thanks for taking the time to share the pics.

Nice. I'm wanting to do the same to my 4runner but I'm contemplating the DIY liners.

I have a full set of marathons in my 08 gmc 1500 and they for perfectly

My marathons for the suburban should be here in 2-3 weeks.

My pleasure

To me Line-X is the only way to go. The LineX ultra is actually off the vehichlrs color code so it looks nearly identical, the only variance is the look for flat and textured

For a retail average of 3k it will last a lifetime and be hard as heck to scratch or year up unlike a wrap or paint job

Hey is that front bumper a Ranch Hand? I am wanting one for my tahoe.

I don't recall the bumper manufacturer

Going to rebuild the forward drive shaft yoke today, it's loose and rattling at low speeds.

Rebuilt and rolling once again. No more noise!

Installed new donut gaskets between the header and exahust flange this evening. Nuts where seized on the studs, 3 on each flange. Took a torch to it, sprayed some PB anti seize and finally got em all off 1/2hr later, then had to drop the front driveshaft to lower the exausht low enough to replace the donuts. Got it all back together now and will see if that cleared up the slight exauhst leak noise.

FYI, stopped by a local muffler shop and was quotes 100 bucks for the job and if they where seized... $300-350.... Umm No Lmao

Wow 10375 views

I'm off Tuesday so here's the todo list

• Replace axle seal
• Program key fob
• Bleed brakes
• Replace rear hatch seal
• Replace wiper spray nozzle
• Fabricate step mounts
• Order & Install interior led lighting
• Transmission fluid change
• Rear differential fluid change
• Transfer case fluid change

I have been driving it to the lake everyday pulling my 21' Ranger and it pulls great

Won a bud light tournament Saturday on Fork



Caught this a few dates earlier

Nice truck and dang nice fish! How much did he weigh in?

x2????

Control arm bushings
Sway bar bushing
Tranny fluid/filter/gasket
Transfer case fluid
Rear diff fluid/gasket
From diff fluid


Had this 8.9 today, client had a 6 & 4.

Just ordered this from LMC

Full weatherstripping for rear hatch (top, opening & gate)
2 new windshield nozzles
Grill support
4 dash retainers (clips)

i hear ya on the exhaust cost, shop here wanted 200 + to change manifold to head gaskets. 14.50 and 30 minutes later done

Feeling like I finally bit off more than I can chew on this one

I need a lift, air compressor and impact

I'm probably going to get it all back together and leave it for a summer project, I'm to dang busy with only tomorrow off for the next 2 months anyway..

Managed to install the new stearing stabilizer bushing and linkage

Pulled the caliper, popped the upper & lower ball joints, pulled CV axle and cussed a little