Posted By: bjankowski
A few CPM154's - 05/31/19 10:18 PM
I wrapped up the week with these four; I did manage to make two sheaths and will finish the rest tomorrow. I'm loving this CPM154, I managed to get 62hrc out of these, after temper. I did cryo them. It's some serious kick butt steel, in cut tests, edge retention, rust prevention. I was on the fence of what steel I wanted to use beside 1075 and this in my books is Super Steel.
That is not a spot on the blade, it’s a reflection.
That is not a spot on the blade, it’s a reflection.