Posted By: J.G.
Is it alright to post a handmade crosspeen hammer? - 03/20/19 02:45 PM
It is not a blade (sorry) but it will help make blades.
My idea of a "fast hammer". 4.5 pound head, that can be swung one handed or two handed, thus the handle that is 24" long, as opposed to 32" long you would typically find on a sledge. Head is 5" long, 2 1/4" wide. It is made from some kind of tool steel that was given to me by the manufacturing plant my dad retired from. Extremely fine sparks came from it, and after annealing, it was still too hard to drill through. I had to get violent with a Number 3 torch tip, on a Victor Journeyman to make the eye hole. It was brought up to near yellow hot, and quenched in used engine oil, in a 5 gallon steel bucket. It boiled that oil for more than a minute. Bois d' arc (osage orange) handle that has been sitting under roof, in open air for several years. I even ground out the wedge from a piece of flat bar.
I've been wanting to make my own flathead axe for a long time. None of the commercial offerings suite me. This hammer ought to help.
My idea of a "fast hammer". 4.5 pound head, that can be swung one handed or two handed, thus the handle that is 24" long, as opposed to 32" long you would typically find on a sledge. Head is 5" long, 2 1/4" wide. It is made from some kind of tool steel that was given to me by the manufacturing plant my dad retired from. Extremely fine sparks came from it, and after annealing, it was still too hard to drill through. I had to get violent with a Number 3 torch tip, on a Victor Journeyman to make the eye hole. It was brought up to near yellow hot, and quenched in used engine oil, in a 5 gallon steel bucket. It boiled that oil for more than a minute. Bois d' arc (osage orange) handle that has been sitting under roof, in open air for several years. I even ground out the wedge from a piece of flat bar.
I've been wanting to make my own flathead axe for a long time. None of the commercial offerings suite me. This hammer ought to help.