Plasti Dip

https://www.harborfreight.com/14-1-2-half-oz-plasti-dip-black-2779.html
Anyone ever use this stuff on tool handles? Is it durable/worth it?

I've used it before
Works well enough, but I'd advise gathering up whatever
you might want to coat and do all of them at once when
you first open the can. After taking the snap on plastic lid
off a couple of times the can I had hardened too much to
be used. You'll probably want to degrease any tool handles
with acetone
Good Luck

It’s good stuff for a lot of things. I don’t think it’ll hold up well on tool handles. It can be peeled off by hand.

X2 Sneaky and Max

Good for replacement grips on arc joint pliars.

My recommendation. Buy once. You trim them with a sharp knife to fit if needed.

https://www.homedepot.com/p/Klein-Tools-Replacement-Handles-for-8-in-to-9-in-Pliers-89/100352100