Posted By: Nick1
Beretta a300 issue - 01/04/22 01:02 AM
After 5 years of flawless action, my outlander 12 gauge is not ejecting spent shells. They get caught halfway or even all the way. This past summer it was professionally cleaned. Any tips on resolving issue. I am not a gunsmith by any means. TIA
Posted By: redhaze
Re: Beretta a300 issue - 01/04/22 10:14 AM
Take the problem to the Shotgun World forum and post it under the Beretta shotgun section. Some pretty knowledgeable Beretta people on there.
Posted By: cleboje
Re: Beretta a300 issue - 01/04/22 01:18 PM
pull the piston from the hanger to see if the piston ring is out of round...if it is, it won't cycle the gun...only fix is to replace the piston ring.
Posted By: txtrophy85
Re: Beretta a300 issue - 01/05/22 08:30 PM
what kind of shells are you using?
a light target load i can see that happening. Not with a high brass duck load
Posted By: cleboje
Re: Beretta a300 issue - 01/06/22 12:59 PM
You have received some very good recommendations on troubleshooting/fixing your problem over at the shotgun world forum...
What have you done so far to put this good information to use...?