Rifle Bedding

Need to have two rifles bedded. looking for someone in the south or west ft worth area.
Recommendations?

I don't have any people to suggest, but if your a hands on kind of person it is pretty simple to do and will save you a lot of money. I think I did mine for less than $20 in materials and was a definite improvement.

yep, not that hard

APR just did one for me think it was $100-$125.........

I usually just buy the accraglass kit and DIY it. It's pretty simple to get right and does not take much time. Use plenty of release agent, make sure all your prep work is done, and have a plan of action before you mix the epoxy. It sets up pretty quick.

DIY, check out some videos, worst thing that will happen, you can't get the action out of stock, and no I didn't do that.

Their are lots of utube vidieo on glass bedding.
The main thing is to sand down to bare wood ware you want the beding to stick.
Mask every thing else then put release agent on the metal.
I hope this helps you.

Call Jonathan at Crimson Accuracy...his bedding is a thing of beauty. He's in Cresson so he's close.

Richard King in Arlington has done several for me does a great job

Alamo does a killer job.

I’m hands on and have seen it done several times. I just don’t have time to do it.
Thanks for the info I’ll give these guys a call.