I just ordered an AR15 in it

Mainly because of cheap ammo being always available and it'll be a pig gun mostly

BUT, lets say I wanted some good brassed cased stuff for deer...

Are yall seeing it anywhere?

I really haven't looked for the good stuff until this afternoon

Surplus Ammo shows to have S&B 123 grain sp in brass cases @ $14.

Thanks, I just went there

Entered everything in and it says it can't ship because its a restricted area

This is in fact a restricted area but not for ammo lol

IDK it is saying that

Your world must be different , I think the cheap ammo is gone forever. I stocked up years ago, but I don't think we will ever see .20rd anymore.

I am calling .40 cheap

$0.40 is cheap for brass 7.62X39.
$0.40 was cheap three years ago for brass 7.62X39.
Steel case bulk is $0.40 now. Tula is $0.37 plus shipping at SGA.

Speaking of SGAmmo ... they have Winchester soft points in brass cases like you want for $1.95 per round (200 rounds $389.50) plus shipping.
The best deal I could find you was $1.75 per round for the same Winchester but it's from "The Castle Arms" and I have never bought from them. I trust SGAmmo.

It's the soft point bullet that's making the price so high. Brass FMJ is less than half price of the soft point. Also BEWEARE there are a lot of corrosive loads making it back out on the market as demilled ammo is being recycled for the primers.

Thanks GG, yeah I was saying about .40 for steel cased

I will check out SGammo

For anyone else who runs one, are y'all upgrading the firing pin?

Thats what I am hearing to do anyway

Id prefer to 100% just run brass but that kinda defeats the purpose of even buying it

The magazine is the most important part regarding function of a 7.62X39 AR platform. I prefer C-products (CPD) magazines.

Thats what I hear

I ordered...

2-AR-Stoner 10 rounders
2-Duramag 20 rounders

I wanted to try and keep the mags straight, idk if that I going to help or not

Made it myself.

Do you have any you are wanting to sell?

I can look at the cost of the parts, make sure I can replace them, and get back to you. If I can replace them, it would not be a problem. But my stuff ain't cheap, it's perfect. You cannot have both.

I have run about 1000 rounds Tula and Wolf Steel in a BCA upper Polymer Lower homemade with no problems and minute of hog accuracy.

I have the cproducts and the promag magazines and both have ran fine but I do not full mag dump.

Thinking about getting a 10 rounder because those fully loaded 30+/- rounders are heavy.