Gentlemen- Fellow THF'ers,
I need your help on my deer stand window part. Our deer stand/blind was damaged and the damage
has caused our glass window to crack. I took it out and want to put plexi-glass in it instead of glass
due to the pressure on the window caused by the frame damage. See the picture below. Taking the window
out I noticed it is missing the side window part seen in the other picture below. So here are my questions:

1. does anyone know where I might be able to buy the window part?
2. has anyone replaced glass and put plexi-glass in the window and have suggestions.?

thanks

Call Larry at Atascosa Wildlife Supply and he will give you the contact phone number for the firm in Houston that provides those windows.

thanks Hudbone for your help, I really appreciate that.
I will go that route.

There is a Deer Blind window company in Cleburne and his windows are legit and they are priced reasonably.

thanks David - do you know the name of the company by chance?

deer view windows... I buy them at Buck Stop in Alvarado... They always keep a very good stock of most of the windows...

^^^This is good info. I dont at all like the type small side to side slide window you have but im pretty sure Buck Stop will have them.

Just bought some from Dickenson Feed Store. Super quick ship can't wait to install.

Everyone,
Thanks so much for the information. I started looking these different companies up and
hope to make some calls next week to see what I can get. It would be nice just to get the
side part that is missing but if not then the next best thing is just to get one of the sliding windows.
I don't need the whole set up just one of the windows. I will also check with them to see if a window
can come with Plexi- glass because I am afraid the damage to the blind has definitely put the glass and
window in a bind. I added some new pictures of what my piece looks like. just an fyi.
Thanks again to all of you for your help. It is very much appreciated.

Dickinson Feed in Dickinson, Tx has the goods. Was there yesterday & bought some windows & a walk-in door for my blind build.

Very easy people to deal with.

Reloder28 and others thanks for the tips and help. I wanted to spend a minute and update everyone
as to what I found out. This may help others in the future. The "Deer Blind Window Company" in Cleburne Tx
has both the single outside edge part and the single window. I sent them the pictures and the nice gentleman responded and said he
has the outside frame part with the latches and cost is $14 plus shipping and the full single window with the latches is $34 plus
shipping. Just an fyi and thanks again everyone for your help.

Thank you, sir. Good to know.

They sell his windows

ask for Jack 817-229-5522

The Original Deer Blind Window Company

Website

yes the company in Cleburne is "The Original Deer Blind Window Company" - thanks

quick update- The guys at "The Original Deer Blind Window Company" came through.
If you have windows like what I show in the picture make sure you measure that width correctly.
It can be 10' or 9.5" in width and the guys knew that and took care of me. Reach out to them if you
need windows. Plus they are in Texas (USA).

thanks

Thank you for the recommendation! But we are actually The Original Deer Blind Window company, (in clebure) not deerview. Different company.
Also Atascosa, Dickinson Feed, Mccoys and Ultramatic are some of our dealers, so they carry our products as well.
Glad we were able to help you!

Thank you for the comment! Glad we were able to help you out!

Buckstop is actually our dealer. Those would be our windows. I know a lot of people confuse our two companies.

+1 on The Original Deer Blind Window Company. Put a post up on here a few months back about needing new windows and they came through! My order was ready in less than a week and I’ve enjoyed them all season long so far! Will def be going with their windows again on my next blind build.