Moving to bath build phase of my container and I need shower wall ideas trying to stay out of the pre-fabric. I did pre-fab last time and didn’t love the costs or end product

Corrugated plastic
RFP panels
Corrugated metal
Vinyl

I’m more a visual person.

https://www.homedepot.com/p/FiberCo...rrugated-FRP-Wall-Panel-F3C320/206084818

I've used something similar to this but was a piece of 1/8" thick paneling and caulked all the seams, worked pretty well...a lot cheaper than that but since you're visual

frp panel would work good and be cost effective, 4x8 fiberglass panels.

1/4" durock (concrete board) on furring strips and you can tile it.

put a hole in the floor and spray some line X on the walls.

move it next door to bill and just use his shower.

glass block

GI shower bucket, hang it from a tree limb, place a pallet on the ground to stand on.

Vrp is cheaper than frp. Same gas station bathroom wall textuer. Same 4 x 8 sheets. Same service life.

Thank you think this might be the most appropriate

I used galvanized metal sheets and drip edge in the corners.

If you can find an old tank they make great outdoor bath/showers

Now that’s cool ^^

2 of the 250 gallon water totes on on top of the other