I just found this spintech feeder plate I had lost in my storage shed 2years ago .I haven't got the set screw that tightens it on the 1/4" shaft..or I would check it out..plan on going to the hardware store to get a screw..does this look like a complete plate?

Yep, just need the screw. I run 2 of them.

After you get the screw, spray regularly with lithium grease. We ran 12 of them on a lease I just got off. I was one of the two repairmen. You need to have spare parts on hand, just sayin'. Not the best designed feeder spinner plate. 'Coons love 'em.

And I've been to the "home office". Not impressive.

We prob have near 20 of them and luckily no problems. We just keep a cage on them and turn them off when we feed protein in the off season.

I got 2 of the spintechs units they work well I spray them with dry lube a few times a year zero issues

clean your keyboard while you're at it

It looks complete except for maybe 1 item.

The Spintech feeder can come with a small sleeve that fits where the motor shaft connects to it.
Normally the Spintech feeders fit the 12 volt motor shafts, the ones with the thicker shaft but you can buy
a 6 volt motor or a small shafted 12 volt spinner (that will fit in those smaller control boxes) and those need that sleeve.

I am not sure what you have but just wanted to share some info I was aware of through my findings.

thanks