I wrapped up the week with these four; I did manage to make two sheaths and will finish the rest tomorrow. I'm loving this CPM154, I managed to get 62hrc out of these, after temper. I did cryo them. It's some serious kick butt steel, in cut tests, edge retention, rust prevention. I was on the fence of what steel I wanted to use beside 1075 and this in my books is Super Steel.



That is not a spot on the blade, it’s a reflection.

CPM154 is what my USA made Kershaw Auto daily carry is made of. Love this thing. It’s spent all week cutting CAT6 cable and still sharp. Great steel for sure.

Those some purdy knives as well.

What do you know about CAT6? I'll have 170k ft installed by this time next week.

Only thing I know is I don’t like running it in a building with no electricity or air conditioning. I only had to run about 4500 ft for our new building that’s is being built out right now. I do not do it professionally lol.

Very nice Bob....

I appreciate it brother, I'm really like that CPM 154.