I have a 2002 5X10 utility trailer I use to haul my ATV. Need to have the bearings serviced\replaced. I'm near I-30/Lake Ray Hubbard area anyone can recommend?

do it yourself.
it's easy enough to do.
if your bearings aren't bad you
just clean and re-pack them.
new seals are 10.00 or less.
just don't forget to chock the
wheels on the opposite side so it
won't roll over you and maim or cripple you.

There is a bit more to it ....use google.

Another recommendation to Do It Yourself. Not difficult, might learn something too.

Worst case scenario, you can replace the entire hub with a pre-packed and assembled bearings, seals for about $35.

Northern tool and equipment should have all the parts if you need to replace anything.

It is very easy to do it yourself. I just did two tandem axle trailers this week and have ten or more to go through as I get time. Northern tool will have everything you need but I like to go to southwest wheel in downtown as their quailty is better and the price is still really good. If you have any questions about it shoot me a txt or pm and I will see if I can help out.

Walter