Posted By: bjankowski
The Pig Sticker - 04/11/18 03:12 AM
The Pig Sticker
I haven't posted in here in a while, I thought it was about time.
I've been working on this design for the last few weeks; I designed especially for the pig hunter made to get bloody.
It's 52100 ball bearing steel 3/16ths thick 60 H.C. blued to help in rust prevention. OAL is 13 inches, tip to brass guard is 8". I wanted a handle that was not going to be slippery, so I made the burlap micarta handle myself. The guard is big enough to prevent hand from slipping on to the blade. The sheath is thick 12oz oil tanned water buffalo. It should make one heck of a pig killing machine.
I haven't posted in here in a while, I thought it was about time.
I've been working on this design for the last few weeks; I designed especially for the pig hunter made to get bloody.
It's 52100 ball bearing steel 3/16ths thick 60 H.C. blued to help in rust prevention. OAL is 13 inches, tip to brass guard is 8". I wanted a handle that was not going to be slippery, so I made the burlap micarta handle myself. The guard is big enough to prevent hand from slipping on to the blade. The sheath is thick 12oz oil tanned water buffalo. It should make one heck of a pig killing machine.