Source for Furniture Grade Board/Plank

Need a piece of furniture grade (oak or maple, can stain to match) wood 36" X 4" X 1.5" to make a replacement skid for a Cracker Barrel rocking chair. Looks like they're made by Hinkle but I don't see a way to get parts from them so I'll have to fix it myself. About five years ago, maybe six, when it was broken, I sent the skid off to the guy in Sherman that restored my parents' heirloom dining set. I called a couple times and he said he was still looking for the proper species because it was not oak like I thought. I told him I didn't care that much and to just get something close. Well I guess he closed shop because he doesn't answer the phone any longer and I never got my broken part back. Where can I get a chunk of wood?

From Hinkle Chair Company.

Found that but I do not have a model number since the chair is made for Cracker Barrel and does not match the model number list they provide. I printed off some of the information to call them later.

Are the rockers held on with screws ?

They're pressed on.

Probably they were attached with glue. Looks like oak, but maybe is Hickory/Pecan. For Hinkle, I’d lay the chair on its side and trace out the rocker skid and mark the hole locations and angle. Send that to Hinkle.

Absolute worst case, bring it to me. I’ve done a few porch rocker skid replacements for a local rancher, and I did make one small rocking chair for a favorite grand niece. And I believe I have some White Oak that would work, or I know I can buy some from Dakota Hardwoods in Waco.

The hard part is matching the new skid to the existing skid, or the rocker will rock a bit unevenly. Because of that, a matching skid from Hinkle would likely be the best match, so tracing it might be best, along with width, height, etc.

I can make it if I had the wood. It won't get used much but I hate to throw it out or leave it in the garage.

Does that white tag list a date or anything ?.

You can get the wood you need at Dakota Hardwoods in the DFW area. Pretty sure they have at least one location. Best to order on the phone, I’ve never had any luck showing up and trying to buy what I needed at the Waco location.

That might be enough information for Hinkley to know what they need.

Dallas hardwoods would have what you need. Trace good leg, make a hardboard templet, ruff cut on bandsaw, finish on router table with a templet following bit. Wood is probably Ash, hickory or white oak as stated above.

EZ project if you have the tools & knowhow.

Got in touch with the chair maker and they are sending a pair of skids for $35. That's cheaper than I could make one.

https://www.hlcdallas.com/

Ordered an OEM pair for $35 shipped. Should be here any day.

New rails came in yesterday. Installed and back in operation.

Forgot about this topic. Here's a picture of the final product. Thanks for the reminder, Bandit.

Nice job