Posted By: garyrapp55
sizing die setup and changes - 11/04/17 03:16 PM
If I have measured my headspace on my fired cases and set up the sizing die to push the shoulder back .001"-.003" and locked in place with my quick change bushing, if I only have 1 rifle of this caliber there should be little to no need to adjust future decapping/sizing, correct?
Posted By: DStroud
Re: sizing die setup and changes - 11/04/17 04:42 PM
Correct.... up to the point where the brass fatigue causes spring back. Then you adjust or anneal.
Posted By: garyrapp55
Re: sizing die setup and changes - 11/05/17 02:46 PM
Thanks for the confirmations. I plan to sent to annealing service after 3 fires regardless of spring back as that seems to be about the standard.
Posted By: Busheler
Re: sizing die setup and changes - 11/11/17 06:20 PM
Never move more brass than is requisite,to establish feed/function.
I always start with false Shouldered Virgins,whenever possible...both for case life and Precision...............