Hornady 143 ELD X out of a 6.5x47

Anyone have a load for Hornady 143ELD X out of a 6.5x47 Lapua?

I think 39.8 grains of H -4350 seated at 2.110 base to ogive will do. This four shot group measures .422 and was the best group out of 6 different loads . Three varget loads starting at 36 grains to 36.6 grains and three loads of H 4350 starting at 39.5 grains to 40.1 . I may try playing with the seating depth to see if it helps shrink that down a bit.

Looks good and it'll get the job done. But I'd dare say that Tony builds a rifle that will shoot better than most of us can. Try shooting groups playing with seating depths increasing in 0.015 increments up to 0.090 -- you'll find one that ought to stack em.

I think I've got and accurate measurement my chamber is 2.144 base to ogive so I will load some up at 2.142 , 2.140, 2.138 and see where that gets me .

That looks like 0.0015-0.002 increases (not 0.015) and you won't see much difference

Try

2.144 - 0.015 = 2.129
2.128 - 0.015 = 2.114
2.114 - 0.015 = 2.099
Etc
Etc

I'm shooting 143 eld-x in my creedmoor and best group was at 0.040 jump -- 1/8 moa -- the other seating depths the groups opened up to .75-1.5 moa.

Gotcha. Thanks . I subtracted by one too many zeros.

Four shot groups. I think 2.115 at 30 thousandths off the lands is where it's at. This rifle is scary accurate.

Very nice.

Nice!! What tool are you using to measure the ogive?

I'm using the Hornady Comparator .