I picked up the below workbench from Home Depot. Cost only $75.00 and it works pretty good. The only challenge with it is the base isn't as wide as I would like and am thinking about adding support at the bottom to provide a little more stability.
Well got the HF table from fed ex tonight when I got home. Much more heavy duty than I expected. Should work just fine for my press and other gear. Pretty sure there will be room for my Blitzenburger fetching jig and a fly tieing vice.
I use one of those benches a lot. For suapping presses around, the presses are mounted on 12 inch square 3/4 inch plywood with counter sunk screws and captive nuts put in the bench so to change out presses it is 4 bolts. The bench is mounted on 3/4 inch plywood on the floor and is bolted to the wall