You don't even work up a sweat with that, pretty nice
Exactly.. I have the RCBS on my garage bench but that thing gets old quick. The Dillon is easier on the hands than the RCBS but this method is way easier and faster. Another thing I have noticed is that with both the Dillon and the RCBS I would get a few that I had to go back and swage again to get the primer to go in. So far not a single one with this setup.
The only issue I have had is if you get a piece with a dented neck it won't slide down the spindle and falls on the floor. I just keep a 223 die in my Forster press adjacent to the Hornady so I bump the brass into it to round out the neck and keep going.
"Anyone taking up handloading necessarily plays with unknown factors and takes chances. But so does anyone who drives a car,goes to a cocktail party,eats in a restaurant,or gets married."
Jack O'Connor 1963