Whats the process for building a 22 Creedmoor if say hypothetically I wanted to build one off a Tikka action?

Is the brass tough to make?

75 grain amax and 3450-3550 fps

Not to hijack, but what is the difference between a 22 Creedmoor and a 22-250?

Bigger case capacity for heavier 22 cal bullets.

I thought 22 creedmoor was based on 308? 22-250 is based on 30-06 I think.

22-250 is the old savage round. Creedmoor is the 30tc but can be made out of 308 with a lot of work.

As a comparison. My .22-250 is a 1:8" twist, and shoots 75 gr A-maxes. But it is 3200 fps MV. So the 22 Creedmoor adds quite a bit of velocity. And I wouldn't be surpised if the Creedmoor has a lower ES due to better case geometry.

Simple, We rebarrel it to 22 creed, then you step down 6mm creed in a single step down. you can do it with bushing dies from redding or were are a couple weeks out from having full length die sets done.

That does sound simple. Could you do this off a Tikka T3 .243 action?

Yep doing a 6.5 creed tika right now. Just talked with Whidden expecting dies here in a couple weeks.

Once you have those Full Length die sets done this might be my next set up!

Awesome shooting and sweet rifle!

Any chance you could post photos of a few cartridges together for comparison....like .223, 22 Creed, .243, 22-250?

Just curious what they look like next to each other.